Category: Motorcycle Engine Parts
-
Motorcycle Engine Oil Seals: Why Seating Matters
Rubber engine oil seals perform two crucial roles inside an engine. Firstly they stop oil (or coolant) from escaping. Secondly, they isolate pre filtered (dirty) oil from the clean oil that feeds your engine’s bearings.
-
How a Motorcycle Crankcase Is Made: The Engineering Explained
How are motorcycle crankcases made? The crankcase is an important and often overlooked part of a motorbike engine. As well as housing the crankshaft it helps control oil flow around the engine, get rid of heat and is often used as a ‘stressed member’ for the frame.
-
Yamaha FZS600 Fazer Oil Drain Bolt and Filter Location…
The Yamaha FZS600 Fazer oil drain bolt and oil filter are located in fairly standard locations for a 4 cylinder, inline 4 engine.
-
Why it’s important to lube and adjust your motorcycle chain…
The motorcycle drive chain is one of the most important (and often overlooked) parts of a motorbike, but why is it important to keep it lubed and properly adjusted?
-
Why it’s important to make sure your motorcycle petrol tank is clean inside…
Clean petrol is vitally important for a smooth running engine (just like oil, coolant etc) and the condition of the tank the fuel is stored in can have a major effect on how the engine starts and runs.
-
Kawasaki ZRX1200 starter and alternator chain tensioner failure…
A Kawasaki ZRX1200 we purchased for spares had a major issue with the engine (specifically the clutch). This problem seems to be a weak point in the ZRX1200 and ZRX1100 engines.
-
What does the motorcycle cylinder barrel do?
In a motorcycle engine, the cylinder barrel (often simply called the cylinder) is a crucial component that forms the main chamber where combustion happens. Note – The term ‘combustion’ refers to the explosion that occurs when the fuel/air mixture is ignited by the spark plug. The cylinder barrel sits between the cylinder head and the…
-
Honda NT650V Oil Drain Bolt and Filter Location…
The oil drain plug and filter on the Hondas 650 Deauville can be tricky to find as, although they are located near to where most bikes have the drain plug and filter located on the Deauville the set up is a little bit different.
-
What does a motorcycle cylinder head do?
What does a cylinder head do and why is it a vital part of a motorbike engine? The main job of the cylinder head is to hold the parts that allow the fuel/air mix into the engine and the exhaust gases out of the engine.
-
What is a motorcycle cylinder bolt (and why can’t you reuse them)?
What is a cylinder head bolt, what do they do and why shouldn’t you re use them? The cylinder head is a vital part of any motorbike engine. The cylinder head bolts secure the cylinder head in place and keep it attached to the engine.